OmniCure® LX300 Controller

OmniCure^® LX300 Controller

The OmniCure® LX300 UV LED Spot Curing System utilizes the highest power and most reliable LED technology in the smallest form factor currently available for UV adhesive curing. This easy-to-use, cost-effective and environmentally friendly system can incorporate up to four LED heads simultaneously and is RoHS and CE compliant. With patented Intelli-Lamp® technology applied to the LED head design, LED temperature and lamp life are monitored allowing for an optimized life guarantee of 10,000 hours of operation, or three years.

» Features & Benefits
» Specifications

Features	Benefits
Highest power LED technology	8,000mW/cm² Maximum Intensity
Intelligent High Performance LED Head with Intelli-Lamp® Technology	Optimized cooling and monitoring for longer lamp life; guaranteed life of 10,000 hours (or three years) provides lower cost of ownership
	Temperature continuously monitored, with built in over-heat protection
	Operating hours monitored and stored on the head and easily accessed via the front panel
	Estimated life of 20,000 to 40,000 hours
	When properly fixtured, will operate continuously without over-heating

Reliable and Easy-to-Use Design	Front panel controls do not require extensive operator training or system downtime
Small Footprint	Easily used as a stand alone solution or embedded into automated manufacturing lines and equipment
	Extra cooling of the unit or environment is not required
Energy Efficient and Environmentally Friendly	Consumes less than 72VA when operating four LED heads at full power
Adherence to Category Safety Standards	RoHS compliant and meets CE requirements

Description
Connectable Heads	1 to 4 individual heads
LED Indicators	LED's indicate: Timer Control, Level, Trigger Mode and Emission (UV ON)
Mode Control	Mode and Up/Down button to control the display mode
Timer	Programmable trigger, adjustable countdown range from 999.9s to 0.1s, in 0.1s intervals or user selectable timing via trigger level
Level	Two output modes: Full and Half
Start/Stop	Start/Stop button to control start or stop of the LED emission
Key Switch	Key switch to turn on/off controller
Flashing Alarm	Over temperature protection and lamp-off alarm for LED heads
Foot Pedal	Foot pedal to control start/stop of LED Emission

External PLC Control
Method	PLC
External Input	Start/Stop, intensity level select, lock out front panel interface and timer mode select
External Output	Emission alarm

Operating Voltage	Controller supply input: 12 VDC, 4A Input to AC adaptor: 100-120VAC / 200-240VAC (+/-10%) & 50/60Hz
Ambient Temperature / Humidity Range	Controller: 5° to 35°C, 85% max. (no condensation)
Storage Temperature / Humidity Range	Controller: -10° to 60°C, 85% max. (no condensation)

*Compatible with our existing 3mm and 6mm lens as well as the new 8mm and 10mm lens
**Compatible with both our existing 365nm Heads as well the new 385nm

Previous Panel Next Panel